Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Skipalicious

Pages: [1] 2 3 ... 80
« on: May 11, 2014, 12:17:32 pm »
I'm here to say that shano and miyuki had posted some hilarious sh*t but unfortunately it was removed. hahahahaha

On side note, this post has been derailed from the original topic. Might want to get back to the topic.

I don't quite know what to say.
Typical HUMAN!
p/s: get back to the topic! Enriched S is out!! Grats to Von!

Wish I could play :(

Mind your language please.

p/s: Shano was the best cleric in his days. Can't say the same now, but I believe he would still be better than 90% of the other active clerics.

General Discussion / Re: Cauchemar Gear Set PROCs
« on: April 25, 2014, 06:03:31 am »
Any active buffs/debuffs/title do not stack.

Forum Q&A / Re: how to change the fonts of aika?
« on: April 12, 2014, 01:59:05 am »
Hello, you can refer here
Though, I do not encourage players to do that since this changes the game client.

Now this is awkward. Perhaps it is different for Unify connection. Please call your ISP and have them check for you. Or atleast have them refresh your connection port.

Well explained with great pictures to illustrate what you should be looking for. Thank you Daddy. (p/s: damn that is awkward)
Here is mine;

TMNet Streamyx.

Technical Issues / Re: this account is already logged in
« on: April 05, 2014, 12:25:20 pm »
Hello, I get this bug from time to time. This usually happen when I get forcefully redirected to login screen due to massive lag or connection issues. I can log in, but I receive that message when I try to click the channel select.  What I think happened is, the system still thinks your previous log instance is still logged in, when in fact you were redirected to login page (logged out), so you just have to force log out the previous instance by spam clicking and log your current instance in.

I simply spam click them and force myself in.

The UI bug issues are commonly known in this version of Aika. As suggested above, you have to restart (exit and relaunch) Aika every few hours to avoid such bugs.

As for DC-ing, and ping result, it appears to me that you are having connectivity issues. Kindly refer to your ISP and have them recheck your connection port. I am using TMNet and I occasionally ask them to refresh my port.
On that note, is your phone line clear? If you hear buzzing sound from your sound, it is most likely that your phone cable needs changing. I have had that issues. By telephone line, I mean, the one that connects your house line to the main line.

Please troubleshoot your internet connection by doing the below steps:
1) Go to your router/modem's page (DLink : (you can check this by typing "ipconfig" in Command Prompt. The default gateway is the one you'd want.)
2) Login (again, the login ID and password varies according to the brand, you can find your default login ID/pass over the internet)
3)  Go to Status
4) Go to Statistic

Please reply back with your SNR Margin and Attenuation Rate (Line Attenuation).

For your reference,
SN Margin (AKA Signal to Noise Margin or Signal to Noise Ratio)
Relative strength of the DSL signal to Noise ratio. 6dB is the lowest dB manufactures specify for modem to be able to synch. In some instances interleaving* can help raise the noise margin to an acceptable level. The higher the number the better for this measurement.
> 6dB or below is bad and will experience no synch or intermittent synch problems
> 7dB-10dB is fair but does not leave much room for variances in conditions
> 11dB-20dB is good with no synch problems
> 20dB-28dB is excellent
> 29dB or above is outstanding

Line Attenuation
Measure of how much the signal has degraded between the DSLAM and the modem. Maximum signal loss recommendation is usually about 60dB. The lower the dB the better for this measurement.
> 20dB and below is outstanding
> 20dB-30dB is excellent
> 30dB-40dB is very good
> 40dB-50dB is good
> 50dB-60dB is poor and may experience connectivity issues
> 60dB or above is bad and will experience connectivity issues

Ostyrion / Re: Bye again
« on: April 05, 2014, 05:11:05 am »
I know this won't solve your problem, but you shouldn't have even joked about that. Some people are just that "Insert word(s) here".

I can't recall his exact crit rate fully buffed, but its over 200 alright. Damn DGs hoarding all dem crits.

I would rather go cored VG armor + 85uni to maximize crit rate. On side note, damn Ichan has +200 crit rate! e.e

Forum Q&A / Re: T3fun has no more Customer Support ?
« on: March 31, 2014, 11:56:30 am »
Not exactly sure since when, but since it was fixed I guess?
UPDATE! The issue with the Mail Inquiry has been resolved! It can be used again!

EDIT: FOUND IT! Here GM Eien Saying
I don't recommend the email method as we are phasing it out. The main support system that we have is the Mail Inquiry system, so please use that one and send followups if necessary.

Note, however, that if the support guys say the case is still being investigated/processed, then that is what is still happening. It would depend on the case though.

General Discussion / Re: Beware of scammers !
« on: March 31, 2014, 06:45:54 am »
Same ol' thing happening in a loop. You should know better.

Forum Q&A / Re: T3fun has no more Customer Support ?
« on: March 30, 2014, 11:32:01 am »
Hello, inquiry by mail has been removed as a customer support method. Please go to , log in, and select Mail Inquiry for Customer Support service.

Pages: [1] 2 3 ... 80